Finally this small baby quilt is off to my local long arm quilter. It measures 41.5 x 41.5. It is Glowing Hearts , a QAL from Sandra @ mmmquilts.
I was able to find an almost big enough piece of batting, and just had to add 4 inches to the length. (No photos of the frankenbatting construction)..
The backing piece that I wanted to use was a bit short also. I usually cut backing by measuring the desired width of the backing x2. . In this case, 49.5. Rather than add a piece on the end , I used the piece I had, folded in half and sewed a 1” seam along the selvage edge. Then pressed it and trimmed the fold off. And trimmed the 1” seam to be 1/2”. And pressed it open. Then of course I cut the length to be 49.5, but the width was still only 45.5”. I had lots of leftover strips from the front. I sewed them end to end until I had 2 strips 49.5” each. Then sewed them together along the long edge. I now had a pieced 4.5’ by 49.5 inches. If I added this new strip to one side, most would be mostly cut off when I trimmed it after quilting. I did that early on in my quilting journey and it looks awful.
![]() |
| See the two strips that ended up on the edge? My quilter didn’t fuss and did a great job of quilting this. It’s “our” quilt and lives on our bed so it’s OK. But it’s not a look I like! |
So I added it to one edge then sewed it to the other edge to make a tube. Folded it in half again and cut the fold opposite the pieced portion. When I opened it up the pieced strips were in the middle. I should have folded it so the pieced strip was off center, but thought of that after the fact.
| Taken in my kitchen with a shadow! ;( |
| Taken outside in the wind! Also :( |
The baby this is made for has not made her appearance yet. Hopefully I’ll have it back from the quilter and bound before she is born. Then I will just have to put the label on it after I know her name and birthdate.
I’m sharing this at Finished or Not Friday hosted by Alycia at Alycia Quilts.
Stay Busy and Stay Happy and Healthy and Hopeful



Good on you getting this done before the baby's arrival! I often piece a back this way. Are you planning to make a special "add on later" label? If not, if that light print in the pieced strips isn't too dense, you can write the label information right on those.
ReplyDeleteI like the way you did that backing! Makes it more fun to look at, too. I'm looking forward to seeing the quilted finish!
ReplyDeleteI really like the way you did your backing! And it will be ready for the baby, what a relief, right?
ReplyDeletewonderful!
ReplyDelete