How I Turned a Flimsy into a Shower Curtain!

 Midweek Makers 

I’ve had several blogger friends ask me how I made a quilt top/flimsy into a shower curtain. I’m going to attempt to explain. If you are not interested, feel free to exit out and go on to the next maker

First, of course, decide which of your UFO tops you will use. I chose a top I made from a QAL called 30 Blocks in 30 Days. 

Then comes measurements. Is the original wide enough for the opening in your shower?

There was a lot of trial and error for us because we had our original tub/ shower combination taken out and a new step in shower installed. I opted for a curved shower rod installed at a custom height. Because Mr Busy is tall, the shower head is higher than normal and therefore the rod is higher. 

This is just to see where I needed to make adjustments. It’s clipped to hangers! 

I started with a clear plastic liner from Amazon. It is 72x78. That gave me a starting point. I needed to add borders to the sides to begin. I divided the width difference in half, added seam allowances and added the borders. I knew I was going to have to add to the length, but I needed to wait until it was hanging to determine that length. 

I made a liner from a piece of muslin I had. You could use any plain light colored fabric. I measured again! Always measure twice ( or more ) cut once! Then sewed the backing(lining) at the sides only. The liner was longer than needed but that gave me some leeway. 

I pressed the seams to the main curtain. Trimmed the top edges even.  I cut strips of Stitch Witchery at 3 inches by the width  and fused the muslin back to the quilt top. This reinforced the top edge for grommets. You could also do buttonholes. I added a narrow binding at the top using a light gray fabric. The color is personal preference. You do you! I chose to use a 1.75” strip and attach per Edyta Sitar’s method. You can find a video on Fat Quarter Shops YouTube channel or search Edyta Sitar Laundry Basket Quilts. 

Oh yippee, I think I was able to insert it here! 😀

Next step was to insert the grommets. I was able to find chrome 3/4” grommets at Hobby Lobby. I knew I needed twelve, to match the purchased liner. I measured and marked the grommet location to match the liner. With Mr Busy’s help I got them installed. I measured 1” down from the binding edge. This gave a bit more above the grommets, and changed the total length needed a bit. 

At this point it was more trial and error. I now needed to add 4” at the bottom of the original quilt top. I cut border rectangles at 6” in colors that coordinated with the flimsy. I calculated 4” + 1/2”for seam allowance + 1 1/2” for a hem.  I didn’t have to match seams, I just made it long enough. I hemmed the curtain by pressing up 1/2” then 1 inch. I machine stitched it down. I cut the lining a bit shorter and used an overlocking stitch on my machine to finish the edge. I had to unstitch the side seam about 2 inches. The muslin lining hangs loose at the bottom. To finish, I top- stitched the side edges so they have a crisp edge. 

I know this is wordy, I hope you get the idea. This is by no means the only way to do this. I just did it one step at a time. I’m pleased with the way it turned out! 

 Our bathroom is small. Our house was built in 1978.

I hung this wall hanging above the towel rack to the left of the shower. I think it compliments curtain. 

I’m sharing at Midweek Makers hosted by Susan of Quilt Fabrication

Thanks for sticking with me on this post! If  you need clarification, please comment and I’ll try to answer more succinctly!